Setting Calibration Data 1 - GE Moisture Target Series 6 User Manual

Chapter 3. Operation and Programming

3.6.4 Setting Calibration Data 1

If you are using a standard M Series probe, the following steps will
Note:
apply. If you are using a VeriDri probe, see Setting Calibration Data 2
on page 63.
60
To update calibration data, from the
Note:
Settings Menu select Cal Data and press
Enter
. The following screen appears.
To access the Cal Data menu, the User
Note:
Passcode is required (see section 3.6.1 on
page 56).
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Once the passcode has been entered,
press Enter
appears.
If you are using a standard M Series probe,
the MH/DP Cal will be highlighted. Press
Enter
. The following screen appears.
Moisture Target Series 6 Hygrometer User's Manual
and the following screen