3.6.5 Setting Calibration Data 2
If you are using a VeriDri probe, the following steps will apply. For a
Note:
standard M Series probe, see Setting Calibration Data 1 on page 60.
3.6.5a
Selecting the Calibration Point
Moisture Target Series 6 Hygrometer User's Manual
Chapter 3. Operation and Programming
To view calibration data, from the Settings
Menu select Cal Data and press Enter
The following screen appears.
To access the Cal Data menu, the User
Note:
Passcode is required (see section 3.6.1 on
page 56).
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Once the passcode has been entered,
press Enter
appears.
If you are using a VeriDri probe, the
FH/DPCal will be highlighted. Press
Enter
. The following screen appears.
To select the calibration point, highlight
Select Cal Point and press Enter
following screen appears.
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Press Enter
to keep the previous value), and return to the
Edit MH/DP Cal menu.
and the following screen
to save (or Cancel
.
. The
63