GE Moisture Target Series 6 User Manual page 21

2.3.1 Basic Mounting (cont.)
Use a screwdriver to extend the bracket screws to the back of the panel
6.
and secure the MTS6 in the panel cutout (see Figure 14).
Figure 14: Securing the MTS6 to the Panel
Using a feeler gauge behind the gasket, check the compression, and
7.
tighten the bracket screws until the gap is 0.028" ±0.002" (see
Figure 15).
Figure 15: Checking the Gasket Compression
Moisture Target Series 6 Hygrometer User's Manual
Chapter 2. Installation
11