Furuno FM-8800D Service Manual page 49

Item Indication
DUP
9
(ON/OFF)
10 SCAN, DUAL
AUTO ACK,
MANUAL
ACK
Transceiver
11
DISTRESS
MODE
Handset
DIST. MODE
12 LAT/LON
13 WATCH CH70
13R AUTO CH
14 xx : xx UTC
AUTO,
15
MANUAL
Operation key
DUAL: [SHIFT]->[9: DW]
SCAN: [SHIFT]->[8: SCAN]
[SHIFT]->[5: ACK]
Indicates "DUP" when selecting DUP channel
NOTE:
Indicates a mode channel allowed by
[MENU]->SYSTEM->CH MODE according to
the power setting in [MENU]->SYSTEM->CH
CONFIG
Indicates the operational SCAN or DW mode.
When operating SCAN or DW, the channel
indication also changes.
1. ACK:
When receiving ACK RQ message from DSC by
ROUTINE, indicates the setting whether ACK
BQ is transmitted by AUTO or MANUAL.
2. DISTRESS MODE:
Indicates after transmitting Distress Alert
NOTE:
Setting COMPLY STATUS in [MENU]->AUTO
ACK
Indicates Latitude/Longitude
NOTE:
1. AUTO/MANUAL is selected by
[MENU]->POSITION, but MANUAL input is
not available valid Pos. data is inputted from the
GPS.
2. [MENU]->ALARM->POSITION OLDER sets
up output interval of alarm indicating the updated
Pos. data.
Indicates that WATCH CH70 is executed on the
CH70 RX board.
*As for the transceiver unit, WATCH CH70
indication changes to DISTRESS MODE after
transmitting Distress Alert.
The state of AUTO ACK is set to ON and
ON-HOOK.
When received the INDVIDUAL/ROUTINE call,
Communication CH changes automatically after
returning AUTO ACK.
（ENA: Auto change, DIS: Manual change）
[MENU] -> AUTO CH
Indicates UTC
NOTE:
1. Input selection of AUTO/MANUAL in
[MENU]->POSITION, but MANUAL input is
not available when valid Pos. data is inputted
from the GPS.
Indication of inputted Pos./Time
NOTE:
Input selection of AUTO/MANUAL in
[MENU]->POSITION, but MANUAL input is
not available when valid Pos. data is inputted
from the GPS.
1-5
1.2 Operation
Outline