Ch Config - Furuno FM-8800D Service Manual

4.4.4 CH CONFIG

This is to set up operating channels for INTL, USA, WX, CANADA, INLAND-WA and
PRIV mode. Setting items are as below.
Setting
MODE
CHANNEL
TRX
DUP/SIMP
TX POWER
Procedure
1. Select [MENU] -> SYSTEM -> CH CONFIG and press [ENT] key.
** Channel config. **
MODE
CHANNEL
TRX
DUP/SIMP : SIMP
TX POWER
1: Back
2. Setting items can be switched with a Channel Knob and a set up value by [1] and [2]
key. Select MODE and CHANNEL. Then, set up TRX, DUP/SIMP and TX POWER
of the channel and press [ENT] key.
3. Press [CANCEL] key. Below pop-up window will appear. Start up power again.
TURN OFF/ON
The setting items
INTL
USA
WX
CANADA
INLND-WA
PRIV
XX
TX ENABLE
RX ENABLE
UNABLE
DUP
SIMP
HI
LOW
: INTL
:01
:TX ENABLE
: HI
2: Next
4-23
4.4 System Setting: Option Menu
Table 4.4.1 CH CONFIG. Setting
Remarks
When setting the specified mode to
operate, carry out ON/OFF setup of each
mode by CH MODE.
Specified a channel according to MODE
TX/RX Operation
Operation only for RX
TX/RX Prohibition: CH is not selectable.
DUP Operation
SIMP Operation
25 W Operation
1 W Operation