Furuno FM-8800D Service Manual page 175

2. Changing batch files
1) Checking PC's COM port number:
Open [Control PANEL] –> [System] –> [Device Manager] and check COM port
number. (e.g. COM3 the installed USB - RS-232C Driver)
2) Select the updating batch file and open the batch file from [File] – "Edit".
3) Change the underlined digit of each batch file to PC's COM port digit.
- UP8800.BAT
program¥uppgNT loader¥fmld.bin bin¥fmdsp.bin 0 0 1 0 1
- UPHS.BAT
program¥uppgNT loader¥fmld.bin bin¥hand.bin 0 0 1 3 1
program¥comdsp -c1 -b57600
- UPIF.BAT
program¥uppgNT loader¥fmld.bin bin¥dmcif.bin 0 0 1 4 1
program¥comdsp -c1 -b57600
e.g. If the batch file is UP8800.BAT,
change "-------- bin¥fmdsp.bin00101" to "00103".
If the batch file is "UPHS.BAT",
change "---- bin¥hand.bin 0 0 1 3 1" to 0 0 1 3 3
"program¥comdsp -c1 -b57600" to c3
As for UPIF.BAT,
it is the same as UPHS.BAT.
4) Select [File] and [Save] for the edited text.
If it is unsuccessful, right click on the batch file icon and select [Property] ->
[General]. For [Attribution], make sure that there is no check mark in "Read Only"
box.
7-6
7.1 Updating