Web Configuration Utility - Siemens SITRANS F US Protocol Manual

WEB Configuration Utility

6.1 WEB Configuration Utility
Introduction
Note
Web Configuration through the Ethernet port is used for every protocol including Ethernet,
N2, BACnet and Modbus except HART.
You can connect to the SITRANS F US Clamp-on Communications Module using a Web
browser (Chrome 19.0 or higher, Firefox 13.0 or higher, Opera 11.0 or higher, Internet
Explorer 8, 9, or 10). If the IP of the Communication Module is unknown, the Toolbox Utility
can be used to locate meters that have the Communication Module option installed and are
connected to the Ethernet network.
If using Ethernet IP, connect the Ethernet connector and refer to the following note.
Note
Ethernet Web Utility Toolbox
This Web utility is used to change settings including IP addresses for multiple meters and to
locate communications modules on the same network.
The web utility can be found at http://www.fieldserver.com/techsupport/utility/downloads.php.
The default IP address is: 192.168.0.2
Note
RS-485 is used for all communication protocols.
F US Clamp-on Communications Protocol Manual
Hardware Installation Manual, 11/2015, A5E34981613-AC
6
61