Connecting The Signal Cable - Eizo CuratOR LX491W Instructions For Use Manual

5.4 Connecting the signal cable

CAUTION
Opening the connector panel cover
Only service may open the connector panel cover. Patients must not be present when the
cover is open.
CAUTION
Connector
Connectors may only be plugged in or removed by Service when the device is switched
off.
NOTICE
Cable
• The picture quality, interference immunity, and emitted interference of the entire system
depend on the cable quality and length.
• When using a BNC to VGA adapter cable, the signal cables, for example, red, green,
and blue, must be of the same length to prevent a loss in image quality.
• Use only the cables specified by EIZO or the transmission links available from EIZO.
Note
Video source settings
• The video source is set on the monitor using the EDID data transmitted via the DDC in-
terface. If the video source cannot interpret the EDID data, the monitor automatically at-
tempts to adjust to the signal clocking of the video source.
• Do not change these settings. Otherwise, the images will not be displayed correctly.
The connection panel for the signal cables and power supply is located on the back of the
monitor. All signal inputs can be connected simultaneously.
Prerequisite
• The monitor is installed in the ceiling suspension or wall mount unit, or on a stand.
• The screws for attaching the cover to the connection panel are accessible.
See also Connector locations [} 18]
Procedure
1. Using a suitable tool, remove the connection panel cover.
2. Connect the signal cables to the monitor.
Note: All signal inputs can be connected simultaneously.
3. Tighten the screws to secure the signal cables.
4. Place the cover back on the connection panel.
CuratOR LX491W
Instructions for Use, 02/2018
5.4 Connecting the signal cable
and Installing the monitor
Connecting
[} 16].
21