Eizo CuratOR LX491W Instructions For Use Manual page 44

Operation
7.8 "Signal" menu
Function
ADC calibration...
Signal change delay
44
Values
Execute
Slider control
Default: 1
Description
Automatically calibrate A/D converter for
the applied video level
Note: This function is only displayed when the
"Saturation adjustment" function is disabled.
The video level range of the system is
checked, and the monitor set accordingly. This
results in optimum adjustment of the individual
RGB A/D converters to the video source.
The calibration results in a larger and more
flexible video level range (e.g., the full bright-
ness is also achieved at 700 mV if the video
level is limited at the value of 700 mV).
Note: A suitable test pattern is required. The A/
D converters have been factory-set and need
not be readjusted.
The function is shown only in conjunction with
a supporting signal source.
Note:
• The "Signal change delay" menu item is not
available unless "Source scan" is set to
"Enabled".
• "Signal change delay" can only be set when
"Picture layout PaP, PiP, PoP" is set to
"Disabled".
The following four parameters are relevant for
the function:
• H frequency
• V frequency
• V total
• Interlaced/non Interlaced
If one of these parameters changes, the moni-
tor treats it as a timing change and initiates
resynchronization via an "Auto in progress". To
prevent this from happening as a result of each
and every minor signal disturbance, the value
representing the permissible number of faulty
or changed borders must be increased in the
case of unstable signal sources.
Note: The higher the slider setting, the longer it
will take for a desired timing change to occur
(delayed by a number of milliseconds).
Instructions for Use, 02/2018
CuratOR LX491W