Table of Contents
Advertisement
4. Attach
slide arms to slide arm sup-
ports: use one 1W' long screw per slide
arm; put fiat washer
on screw; insert
screw through
slide arm; on other end of
screw put another
flat washer; put screw
through
slide arm support;
on end of
screw put lock washer,
then hex nut and
wrench
tighten.
5. Attach
slide arms to lock handle
chan-
nels: use one _" long screw per slide arm;
insert screw through
slide arm; on end of
screw put flat washer; put screw through
lock handle
channel;
on end of screw put
square
lock nut and tighten.
Install Drawers
(Only Drawer Model)
1. Slide each drawer into place and push
all the way in.
2. Pull each drawer
out as far it will go.
They should
not come all the way out. If
any do, use screwdriver
to bend out stop
tabs on slide brackets
and re-test
drawer.
To Remove
Drawers
(Only Drawer
Model)
1. Llse screwdriver
to push in one stop
tab on right slide bracket
and at same
time pull drawer
out slightly.
2. Repeat
with left slide bracket
and pull
drawer all way out.
Alignment
and Adjustment
Go to Alignment
and Adjustment
Section
and follow all instructions.
You cannot
use the saw until it is aligned and ad-
justed.
It may be helpful
to read the Con-
trols Section
before
proceeding
with
alignment
and adjustment.
Reinaining
parts will be installed
in Digi-
tal Display Section.
Assembly
!
33
Hide quick links:
Advertisement
Table of Contents
