Craftsman 113.197511 Owner's Manual page 27

Assembly
Mount Motor
1. Loosen guard clamp screw and lift
guard off blade.
Motor
2. Use both blade wrenches in scissor ac-
tion to loosen blade nut. Note:Arbor
shaft has left-hand threa&. Turn nut clock-
wise to loosen.
3. Remove and set aside nut, blade col-
lars and blade. They, wifl be re-installed
later during alignment and adjustment.
4. I_,ock rip lock. Turn handwheel clock-
wise to raise radial arm about 3".
5. Remove styrofoam packing blocks, and
clean small pieces of styrofoam off saw.
I.ifl motor out of styrofoam base and set
on center channel of saw. Remove three
table sections and fence.
6. Remove lock nut and flat washer from
motor support.
7. Slide bevel cncoder to top
position so
it
will fit into notch in plate index on motor.
Guard
Clamp
Screw
8. Slide motor onto motor support. Make
sure motor is firmly in place.
9. Re-install flat washer and lock nut.
Tighten lock nut and at same time move
bevel lock (located near saw handle)
back and forth. Do not over tighten nut.
[_-____ Rip Lock
_ Motor Lock Nut
Lock Support Washer
27