Table of Contents
Advertisement
Assembly
5. Position
rear support,
with slide brack-
ets attached,
inside right side panel,
so
short tabs point up, and solid surface
faces front.
6. Attach
rear support
to side panel:
use
two screws (insert screws through
side
panel);
on end of each screw put washer,
then nut, and wrench
tighten.
7. Attach
slide brackets
to front inside
edge of side panel:
use three screws (in-
sert screws through slide brackets);
on end
of each screw put washer,
then nut, and
wrench
tighten.
8. Repeat
steps 4-7, installing
slide brack-
ets to
right
side of another
rear support
and attaching
rear support,
with slide
brackets
attached,
to left side panel.
Short
Tabs
_
-_
9. Attach
four slide brackets
to remaining
rear support,
one on each side of center
hole and one on each side of second hole
from top: use four screws (insert screws"
through larger hole in slide bracket);
on
end of each screw put washer, then nut,
and wrench
tighten.
Set this" rear support
cL_idefor later use. Remaining
two slide
brackets will be installed later.
10. Go to "Attach
Side Panels to Bottom
Shelf."
Assemble
Side Panels(Only
Door
Model without Casters)
1. Set out:
-right side panel
-left side panel
-two spacers
-four leveling
feet
-four vq" diam x 1/2"long truss head
SCreWS
-four v4" diam lock washers
-four 1/a"diam hex nuts
-eight _ia"diam hex nuts.
J
Larger
Hole
19
Hide quick links:
Advertisement
Table of Contents
