Craftsman 113.197511 Owner's Manual page 24

Assembly
Attach Doors
1. Set out:
-two doors
-two magnetic catches with stop plates
-four #6 x _/2"long pan head plastite
screws
-four #6 x ya" long pan head screws
-eight #10 x 1/2" long pan head plastite
screws.
2. Put both doors face down on floor. At-
tach magnetic catch to inside surface of
each door: use two #6 x v2" long screws
per catch.
3. Attach magnetic stop plate to each side
of center support: use two #6 x 3!g'long
screws per stop plate (insert screws
through plate and into small holes).
4. Attach doors to hinges on side panels:
use four #10 x 1/2" screws per door.
5. Go to "Attach Handwheel".
Complete Center Slide Assembly
(Only Drawer Model)
1. Set out
-center support
-upper support
-rear support with four slide brackets
attached
-two slide brackets
-sixteen _" diam x v_" long truss head
screws
-sixteen v'4"diam lock washers
-sixteen l/4" diam hex nuts.
!
¢
Side
Panel
Doors
/\
f
Magnetic Catch
Magnetic
Slop Plate
tJ
Magnetic Catches
c
24