Table of Contents
Advertisement
Assembly
Finish Cabinet
(Only Door Models;
Drawer Model:
Go to "Complete
Cen-
ter Slide Assembly")
1. Set out:
-upper
support
-center
support
-eight 1/4"diam x 1/2"long truss head
screws
-eight v4" diam lock washers
-eight 1/4"diam hex nuts.
2. Rest center
support
on floor, solid sur-
face down. Slide upper support
into cen-
ter support to form an "L" shaped
assembly.
3. Attach
center
support
to upper sup-
port: use two screws (insert screws through
long sides of center support);
on end of
each screw put washer,
then nut, and
finger tighten.
4. Turn "L" shaped
assembly
90° to right,
so upper support
is parallel
to floor and
solid surface
is on top. Slide into front of
cabinet,
under
front and rear skirts, so
bottom
of center
support
fits onto lower
support.
5. Attach
center
and upper supports
to
front skirt: use two screws (insert screws
through upper support);
on end of each
screw put washer,
then nut and wrench
tighten.
6. Attach
upper support
to rear skirt:
use
two screws (insert screws through upper
support);
on end of each screw put
washer,
then nut and wrench
tighten.
7. Attach center
support
to lower sup-
port: tilt cabinet
back; use two screws (in-
sert screws through sides of center support);
on end of each screw put washer,
then
nut and finger tighten.
Support
_-
Center
Support
Front
Skirt
\
Upper
Support
Center
Support
Lower
Support
23
Hide quick links:
Advertisement
Table of Contents
