Craftsman 113.197511 Owner's Manual page 31

Assembly
3. Snap one U-clip onto left side of center
channel, so hole lines up with hole in
channel. Snap remaining four U-clips
over holes in sides of saw frame.
U-Clip On
Center Channel
U-Clips
U-Clips
4. Put 17/64" in. diam x s_s '' out. diam washer
on each W4" long mounting screw.
5. Stand table on edge. Put mounting
screws, with washers attached, into each
of five mounting holes (insert screw
through table top); on end of each screw
put rubber bushing.
Rubber
Grommet
Table Rail
€
Mounting
Holes
Front Table
On Front Edge
Mounting
Holes
6. Place table, top side up, on saw so
mounting screws line up with holes in U-
clips. Note: Table will extend about 1"
beyond trim caps.
7. Tighten mounting screws into U-clips
until heads just touch table. Note: Make
sun" rubber bushings are not squeezed.
8. Start cup point set screw through each
leveling hole and into tee nuts. Use v_"
hex wrench to tighten screws until flush
with table.
Leveling
Leveling
Holes
31