Table of Contents
Advertisement
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
A
Figure 6. G0836 mill/drill unit.
-14-
Box 1 (Figures 6–7)
A. Mill/Drill Unit ............................................... 1
B. Bottle for Oil ............................................... 1
C. Power Cord for Mill/Drill .............................. 1
D. Power Cord for Power Feed ....................... 1
E. 5A Power Supply Adapter .......................... 1
F.
Chuck Key .................................................. 1
G. Spindle Wrench .......................................... 1
H. Quill Lock Lever .......................................... 1
I.
T-Nuts M12-1.75 .......................................... 2
J.
Open-End Wrench 17/19mm ...................... 1
K. Open-End Wrench 14/17mm ...................... 1
L. Open-End Wrench 8/10mm ........................ 1
M. Hex Wrench 8mm ....................................... 1
N. Hex Wrench Set, 3, 4, 5, 6mm ................... 1
B
C
E
F
J
K
Figure 7. G0836 inventory.
Model G0836 (Mfd. Since 09/17)
Qty
D
I
G
H
M
N
L
Advertisement
Table of Contents
