Table of Contents
Advertisement
Quill Outside Surface
Lube Type ............. SB1365 or ISO 68 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ........8 Hours of Operation
To lubricate quill outside surface:
1.
Fully lower quill and lock in position.
2.
Without disturbing grease on quill rack, clean
outside smooth surface of quill with mineral
spirits and shop rags (see Figure 65).
Quill Outside
Surface
Figure 65. Quill lubrication area.
3.
When dry, apply thin coat of ISO 68 or
equivalent oil to smooth surface, then move
spindle up and down to evenly distribute oil.
Quill Rack
Lube Type ............. T26419 or NLGI#2 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency .....................6–12 Months
To lubricate quill rack:
1.
Lower quill to gain full access to quill rack
(see Figure 66). Lock in position.
Figure 66. Location of quill rack.
-38-
2.
Clean teeth with mineral spirits, shop rags,
and brush.
3.
When dry, apply thin coat of grease to teeth
and raise/lower quill several times to evenly
distribute.
Note: Re-apply oil that may have been
removed during the cleaning process to the
smooth quill surface around the rack.
Replacing Spindle
Depth DRO Battery
If the spindle depth DRO stops operating correct-
ly, the 3V lithium cell battery must be replaced.
To replace DRO battery:
1.
Slide battery cover to right to expose battery,
as shown in Figure 67.
Figure 67. Battery cover for spindle depth DRO.
2.
Remove old battery, dispose of it according
to state and federal regulations, then replace
it with a new one.
3.
Replace battery cover.
Quill
Rack
Model G0836 (Mfd. Since 09/17)
Battery
Cover
Advertisement
Table of Contents
