In Use/Charging Led Display State Priority (All Red Leds); Temporary Tone Activation; Ear Piece Volume Adjustment - VTech PDL GX Manual

V
TECH
TITLE PDL GX Internal Product Specification
MODEL PDL GX
When the telephone line is ringing, the In Use/Charging LED will flash low intensity RED at a rate of 16
Hz during the ON cycle of the power ringing signal.

3.15.2.1 In Use/Charging LED Display State Priority (All Red LEDs)

LED Display State
Ringing
On Hold
In Use
Charging
No Handset in Cradle and Idle Mode

3.16 Temporary Tone Activation

When the unit is setup for PULSE dialing (see Section 3.13 Setup Mode Options for details on dial type
setup), the user can temporarily switch to tone mode by pressing the
active until the OFF key is pressed.

3.17 Ear Piece Volume Adjustment

The user can adjust the volume level of the incoming audio by pressing the
done while the phone is off hook, not on HOLD, and not in any menu selection modes. The initial press of
either the or key will bring up the volume display at the current setting.
To adjust the volume press the
characters shown on the display denotes the volume levels. There are in total, 4 volume levels.
The volume level display will remain active for 5 seconds after the last
Reference: PRC 00DM
This document is proprietary to V
Specifications are preliminary and are subject to change without notice.
E
NGINEERING
16 HZ FLASHING
LOW INTENSITY RED
during ON power ring cycle
LOW INTENSITY RED
LOW INTENSITY RED
HIGH INTENSITY RED
WPMVNF!]]]] WPMVNF!]]]] WPMVNF!]]]] WPMVNF!]]]]
or key to select the desired volume level. The number of filled
Revision: 3.0
E C L
TECH NGINEERING ANADA
C L
ANADA
Indication
4 Hz FLASHING
SOLID
SOLID
OFF
key. This tone mode shall remain
or
or key press.
.
TD
IMITED
Priority
1
(HIGHEST)
2
3
4
5
(LOWEST)
key. This can only be
Page: 47 of 56
26649