Telephone Base And Charger; Battery Installation; Battery Charging - VTech DS6521-32 User Manual

Telephone base and charger installation
Install the telephone base and charger as shown below.
Telephone base
power adapter
Electrical outlet
not controlled by
a wall switch
• Use only the power adapter and battery supplied with this product. To order a
replacement, visit our website at www.vtechphones.com or call  (800) 595-95.
In Canada, go to www.vtechcanada.com or call  (800) 267-7377.
• The power adapter is intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into
a ceiling, under-the-table or cabinet outlet.

Battery installation

Install the battery as shown below.
. Plug the battery connector
securely into the socket.
3. Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
• If the handset will not be used for a long time, disconnect and remove the battery to
prevent possible leakage.

Battery charging

Once you have installed the battery, the screen indicates the battery status (see
the table below). For best performance, keep the handset in the telephone base or
charger when not in use. The battery is fully charged after 0 hours of continuous
charging. Refer to the online user's manual for battery operating times.
Battery indicators
The screen is blank,
or shows PLACE IN
CHARGER and
The screen shows
LOW BATTERY and
flashes.
The screen shows
HANDSET X.
• If you place the handset in the telephone base or charger without plugging in the
battery, the screen displays NO BATTERY.
Telephone wall jack
Telephone base
Battery status
The battery has no charge
or very little charge. The
flashes. handset cannot be used.
The battery has enough
charge to be used for a
short time.
The battery is charged.
A DSL filter (not included)
is required if you have DSL
high-speed Internet service
Telephone line cord
2. Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
4. Place the handset in the telephone
base or charger to charge.
CHARGE light
remains on
when charging.
2
Charger adapter
Electrical outlet
not controlled
by a wall switch
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery
charged, place it in the
telephone base or charger
when not in use.
Charger