Other Motion Control Function Blocks; High-Speed Counter - Delta DVP-20PM Applications Manual

5
Applied Instructions and Basic Usage
The motion control function block named FB
motion control function block named FB2 is s
Set Execute to True
before the execution of t
status of the M-code which is being executed. When an M-code is execut
is used to clear the M-code which is executed.
5. Modules which are supported
The motion control function block T_Mcode supports DVP20
5.12
Oth er Motion Contr
5.12. 1

High-speed Counter

1. Moti on con trol function block
The motion co ntrol function blo
Channel input pin indicate
input pulse type. The ExtRstEN input pin is used to set an external reset switch. The value of the
InitialValue input pin is
p in is the value in the counter specified.
T he input terminals for the h
below.
The input terminals in the solid frame are for high-speed counter 0, and the input terminals in the dotted
frame are for high-speed counter 1.
5-252
. Execute the G- codes
he G -codes in the
ol Function Blocks
ck T_HCnt is used to start a high-speed counter. The value of the
s a counter number, and the value of the InputType input pin indicates an
the ini tial value in the counter specified, and
igh-speed counters in a DVP-20PM series motion controller are shown
24G +24V
START0 DOG0
DVP-20PM
A0+ B0+ A1+ B1+
A0- B0- A1-
1 is set so that an Ox motion subroutine is executed. The
et so that the status
in t he Ox motion subr o
Ox motion subroutine s
PM00D and DVP20PM00M.
S/S0 STOP0 LSP0
LS N0 PG0+ START1 DOG1
CLR0+ CLR1+ FP 0+
B1- CLR0- CLR1- FP0-
of an M-code is checked.
utine specified. Set Execute1 to True
pecified is complete. Check the
ed, Valid is set to True. CLR
the value of the C ountValue output
PG0- S/S1
RP0+ FP1+
RP0-
FP1-
DVP-20PM Application Manual