Remington 500 Series Operating Manual page 8

Overhead Chute Control (w/
Chute Control Rod)
Chute Assembly
Overhead Chute
Control Rod
Figure 2-12
1. Remove wing nut (a) and hex
screw (b) from chute control head and
clevis pin (c) and cotter pin (d) from
chute support bracket. Position chute
assembly (forward-facing) over chute
base. See Figure 2-13.
Chute Control
(b)
(c)
(d)
(a)
Chute
Chute Base
Figure 2-13
8 S 2 — A
ection SSembly
2. Place chute assembly onto chute base
and secure chute control head to chute
support bracket with clevis pin (c) and
cotter pin (d) removed in Step 1.
See Figure 2-14.
3. Finish securing chute control head to
chute support bracket with wing
nut (a) and hex screw (b) removed in
Step 1. See Figure 2-15.
4. Insert chute control rod into the support
bracket on rear of the dash panel. See
Head
Figure 2-16.
Chute
Support
Bracket
& S -U
et p
(c)
(d)
Figure 2-14
(b)
(a)
Figure 2-15
Figure 2-16
5. Remove hairpin clip (a) from rear of
chute control head. See Figure 2-17.
(a)
(b)
Figure 2-17
6. Insert chute control rod (b) into rear
of chute control head. See Figure 2-17.
Secure chute control rod to chute
control assembly with hairpin clip (a)
removed in Step 5.
STOP
Continue to Set-Up (page 12).