Using Setup Erase - Fluke Hydra Series II User Manual

Using Setup Erase

Perform the procedure in Figure 3-7 to remove a setup file from the memory card.
Removing a file does not interrupt the sequential SEtxx file names assigned with the
SEtUP STORE command. When SEt99 is reached, the instrument loops back to reuse
previously assigned file names that have been erased or skipped over. To exit at any time
(file not erased), press the C key.
FILES
ENTER
ENTER
ENTER
ENTER
Figure 3-7. Using SETUP ERASE to Delete Configuration Files
Selecting the SETUP mode. Press the FILES
FILES
key to access the FILES menu.
up/down arrow keys until SEtUP is displayed,
Init
then press the ENTER key. The menu changes
StAt
to SEtUP.
dir
Table 3-1.
dAtA
SEtUP
Selecting the ERASE mode.
SEtUP
up/down arrow keys until ErASE is displayed in
the SEtUP menu, then press the ENTER key.
ErASE
The menu changes to ErASE.
StorE
LOAd
Selecting a SEtxx File to ERASE. Press the
ErASE
up/down arrow keys until the SEtxx file to be
erased is displayed in the ErASE menu, where xx
SEt99
represents a number from 00 to 99, then press
SEtxx
the ENTER key. The menu changes to SUrE.
SEt00
Erasing a SEtxx File. Press the up/down arrow
SUrE
keys to select yES or no in the SUrE menu, then
press the ENTER key. yES will erase the file, no
yES
will cancel the procedure and nothing will be
no
erased.
ENTER, or displays nonE if there are no files to
erase. Press the CANCL key to exit. If an error
Typical message occurs, see Table 3-1.
Required
Memory Card Operations
Setup File Procedures
If an error message appears, see
The procedure repeats after pressing
3
Press the
Press the
op43f.eps
3-11