Fluke Hydra Series II User Manual page 47

Key
F
Calls up the menu to set the function for the channel
A
Calls up the menu to set alarm limits
B
Calls up the menu to set scaling on the channel.
C
Used to exit any setup menu and return to Inactive Mode, without saving
settings you've selected thus far. Exceptions exist under the following two
conditions
If you cancel out of the alarm menu part way through defining alarm limit
just-made entries for alarm limit
If you cancel out of the Mx+B menu part way through defining the B value, any
just-made entries for the M value will still take effect.
This key also provides a handy way to remove the Totalizer value or Review
data from the display.
G D
Used to change the channel number and to step through choices in any of the
setup menus. These arrow keys have an automatic repeat action when held
down for more than 1 second.
J H
Used to step through choices in several of the setup menus. These arrow keys
have an automatic repeat action when held down for more than 1 second.
E
Used to accept a selection just made in any setup menu.
I
Allows you to change the scan interval. Scanning becomes continuous when
the interval is set to 0:00:00.
P
Accesses menus related to memory card operation, including status, directory,
and manipulation of all SEtxx and dAtxx files.
N
Calls up the Review array of MIN, MAX and LAST values to the display.
K
Accesses secondary functions under various keys, as described below. When
this key is pressed, "SHIFt" appears on the right display, but automatically
disappears if you have not made a selection within 5 seconds or press
L
Prints out the Last values of the Review array or contents of the memory card
directory via the RS-232 computer interface.
O
Calls up the present Totalizer count to the display.
Q
Turns the Scan function on or off.
Triggers a single scan when the instrument is under remote control without
lockout (REMS).
M
Turns the Monitor function on or off
K J
RATE Allows you to change the scanning speed: "Slo" for highest accuracy, or "FASt"
for highest throughput
K I
CLOCK Allows you to set the internal day/date clock
K P
MODE Allows you to select the destination and conditions for which scan
measurements will be automatically printed or logged.
Table 1-3. Front Panel Keys Description
Description
S T
and for the channel.
S
will still take effect.
Preparation for Use
Controls and Indicators
T
, any
C
.
1
1-21