Fluke Hydra Series II User Manual page 265

—2—
2-wire accuracy, A-8, A-12
—A—
AC operation, 1-13
Ac signal cross talk in a dc voltage channel, B-1
Ac signal cross talk into a frequency
channel, B-3
Ac signal cross talk into an ac voltage
channel, B-2
Ac signal cross talk into an ohms channel, B-2
Ac signal crosstalk into a temperature
channel, B-3
AC Voltage Measurements, A-8
accuracy verification test, 7-7
adjusting the handle, 1-12
Alarm indications while monitoring, 2-19
Alarm indications while reviewing, 2-19
Alarm indications while scanning, 2-18
Alarm outputs, 1-17
alarm outputs and digital I/O, 1-9
alarm outputs connections, 1-17
Alarm outputs for channel 0 to 3 using the alarm
outputs connector, 2-19
Alarm outputs for channels 4 to 20 using the
digital I/O connector, 2-19
alarms, 1-9
Alarms and autoprinting, 2-20
Alarms and monitor-alarm triggering, 2-20
Alarms and Mx+B scaling, 2-20
applications software, 1-9
—C—
calibration, 7-21
changing the memory card during scanning, 3-5
channel integrity test, 7-8
cleaning, 7-3
Clearing alarm parameters from a channel, 2-19
Clearing Mx+B scaling from a channel, 2-23
Common mode rejection, A-10
computer interface command set, 4-18
computer interface commands and
operation, 4-12
computer operation, 1-8
configuring a channel to measure ac volts, 2-10
configuring a channel to measure dc volts, 2-9
configuring a channel to measure frequency, 2-12
configuring a channel to measure resistance, 2-11
configuring a measurement channel, 2-8
configuring for printer operations, 5-5
configuring the instrument for computer
operations, 4-5
configuring the instrument for modem
operations, 6-7
configuring the instrument for operation, 2-6
configuring the instrument modem for modem
operations, 6-4
configuring the pc for computer operations, 4-6
connecting the instrument to a pc, 4-3
connecting the instrument to a power
source, 1-12
connecting the instrument to a printer, 5-3
connecting the modem to a pc for modem
configuration, 6-4
connecting the modem to an instrument, 6-6
connector set, 2620a-100, 1-10
controls and indicators, 1-19
crosstalk, 1-14
Cross-talk rejection, A-8
—D—
data file procedures, 3-12
Index
1