G60T Module - Extreme Networks BlackDiamond 10K Series Installation Manual

BlackDiamond 10808 I/O Modules
NOTE
See the ExtremeWare XOS Concepts Guide and the ExtremeWare XOS Command Reference Guide for
more information about configuring I/O modules.

G60T Module

Figure 29 shows the G60T module.
Figure 29: G60T module
Module status LEDs
RJ-45
connector
ports
EX_004
The G60T module has 60 autosensing 10/100/1000BASE-X ports that use standard RJ-45 connectors. If
you have one MSM module installed, all ports on the G60T module are switched through that MSM
module. If you have two MSM modules installed, the top 30 ports on the G60T module are switched
through the MSM module in slot A, and the bottom 30 ports are switched through the MSM module in
slot B during normal operation.
The default configuration of the G60T module is as follows. All ports:
• Are added to the default VLAN as untagged
• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth)
• Operate in auto-negotiation mode
LEDs
The G60T module has the following LEDs:
• Module status
• Port status
• Port speed
For information about the LEDs and their activity on the G60T module, see "I/O Module LEDs" on
page 71.
68 Extreme Networks BlackDiamond 10K-Series Switch Installation Guide