Standard Rack Installation - Extreme Networks BlackDiamond 10K Series Installation Manual

Standard Rack Installation

To mount the BlackDiamond 10808 switch into a standard 19-inch (48.26 cm) rack, you need the
following tools, equipment, and resources:
• Helper bracket (provided)
• A minimum of four appropriate screws to secure the helper bracket (not provided)
• # 1 Phillips screwdriver
• A minimum of two people to help install the chassis into the rack
Before you Begin
Locate the shipping status indicators on the side of the shipping carton.
• Tilt watch indicator
• Shock watch indicator
Figure 11: Shipping status indicators
Each indicator has two color-coded states, or modes: a good, white state, and a warning, red state. A
smooth shipping procedure should leave all four indicators in good, white states. Figure 12 shows the
tilt watch and shock watch indicators on both conditions.
Extreme Networks BlackDiamond 10K-Series Switch Installation Guide
Tilt watch
Cardboard box
Clip locks
Pallet
Installing the Chassis
Shock watch
EX_083
41