Table of Contents
Advertisement
BlackDiamond 10808 Switch Management Module
d If you install a slave MSM, use the
configurations from the master MSM to the slave MSM.
You are not prompted to synchronize the images and the configurations from the master to the
slave. If not synchronized, the slave uses its image and the master configuration. This
image/configuration mismatch will likely cause the switch to operate differently after failover.
CAUTION
Depending on the size and complexity of your network, you should install and configure a slave
MSM when network disruption will be minimal. You may need to reboot your switch after you use the
command.
synchronize
10 Store the module packaging for future use.
11 Leave the ESD strap permanently connected to the chassis so that it is always available when you
need to handle ESD-sensitive components.
To install additional MSMs, repeat steps 1 through 6.
Verifying the MSM Installation
After you install the MSM, verify that it is working correctly by checking the LEDs on the front panel of
the MSM. If it is operating normally, the front-panel LED indicators appear as follows:
• SYS LED—Green blinking
• MSTR LED:
— Green: Operating as master
— Amber: Operating as slave
• ENV—Green
• ERR—Off
• Link/Activity:
— Green: Link is up.
— Amber: Packet activity is occurring.
For more information about MSM LED activity, see "MSM LEDs" on page 61.
Removing MSMs
The BlackDiamond MSM is hot-swappable. You do not need to power off the system to remove a
module.
You need the following tools and equipment to remove an MSM:
• ESD-preventive wrist strap
• # 1 Phillips screwdriver
• Replacement MSM
64
command to replicate all saved images and
synchronize
Extreme Networks BlackDiamond 10K-Series Switch Installation Guide
Advertisement
Table of Contents
