Where To Go From Here - Fluke 5520A Getting Started

5520A
Getting Started
SERIAL 2
TO UUT port

Where to Go from Here

To locate specific information in the Operators Manual (provided as a pdf file on the CD-
ROM) refer to the following list:
•
•
•
•
•
•
•
•
•
•
4
SERIAL 1 FROM HOST port
5520A
RS-232 Remote Operation using the
5520A
RS-232 Remote Operation using the
Figure 2. RS-232 Remote Connections
Unpacking and setup: Chapter 2, "Preparing for Operation"
Installation and rack mounting: Chapter 2, "Preparing for Operation," and the rack
mount kit instruction sheet
AC line power and interface cabling: Chapter 2, "Preparing for Operation"
Controls, indicators, and displays: Chapter 3, "Features"
Front panel operation: Chapter 4, "Front Panel Operation"
Cabling to a UUT (Unit Under Test): Chapter 4, "Front Panel Operation"
Remote operation (IEEE-488 or serial): Chapter 5, "Remote Operation"
Calibrating an Oscilloscope: Chapter 8, "Oscilloscope Calibration Options"
Accessories to the 5520A Calibrator: Chapter 9, "Accessories"
Performance Specifications: Chapter 1, "Introduction and Specifications"
SERIAL 1 FROM HOST port
SERIAL 1 FROM HOST port
COM port
SERIAL 1 FROM HOST and
SERIAL 2 TO UUT ports
COM port
PC or Terminal
PC or Terminal
Unit Under Test
nn031f.eps