Operation Overview; Where To Go From Here - Fluke 5080A Getting Started Manual

riešenia na presné meranie
•
Use only a power cord that is in good condition. Refer
power cord and connector changes to qualified service
personnel.
•
Do not operate the Calibrator in an atmosphere of explosive
gases.
•
Verify the voltage applied to the unit under test does not
exceed the insulation rating of the UUT and the
interconnecting cables.
•
Do not remove the Calibrator cover without first
disconnecting the power cord.
•
Do not operate the Calibrator without the cover properly
installed. Access procedures and the warnings for such
procedures are contained in the Service Manual. Service
procedures are for qualified service personnel only.
•
Do not use the Calibrator if it appears damaged or operates
abnormally. Refer all questions of proper Calibrator
operation to qualified service personnel.
To avoid damage to the Calibrator, do not apply voltage in
excess of the marked rating to any terminal.

Operation Overview

The 5080A Calibrator may be operated at the front panel in the local mode, or remotely
using RS-232 or Ethernet ports. For remote operations, several software options are
available to integrate 5080A operation into a wide variety of calibration requirements.
Typical local operations include front panel connections to the Unit Under Test (UUT),
and then manual keystroke entries at the front panel to place the Calibrator in the desired
output mode. The front panel layout facilitates hand movements from left to right, and
multiply and divide keys make it easy to step up or down at the press of a single key. You
can also review 5080A Calibrator specifications at the push of two buttons. The backlit
liquid crystal display is easy to read from many different viewing angles and in different
lighting conditions, and the large, easy-to-read keys are color-coded and provide tactile
feedback.

Where to Go from Here

To locate specific information concerning the installation and operation of the 5080A
Calibrator, refer to the following list:
•
"Unpacking and Inspection" in this manual.
•
Installation: 5080A Operators Manual, Chapter 2, "Preparing for Operation."
•
AC line power and interface cabling: "Connecting to Line Power" in this manual.
•
Controls, indicators, and displays: "Front-Panel Features" and "Rear-Panel Features
in this manual.
•
Front-panel operation: 5080A Operators Manual, Chapter 4, "Front-Panel
Operation."
•
Cabling to a UUT (Unit Under Test): 5080A Operators Manual, Chapter 4, "Front-
Panel Operation."
W Caution
http://www.elso.sk
Calibrator
Operation Overview
3