Signal Processing Products Control Program; Installing The Sppcp - Extron electronics RGB-DVI 300 User Manual

4.
5.
6.

Signal Processing Products Control Program

All the features of the RGB-DVI 300, RGB-HDMI 300, and RGB-HDMI 300 A that can be
controlled by SIS commands can also be controlled by a computer that is running the Signal
Processing Products Control Program (SPPCP).

Installing the SPPCP

The control program is available on the disk provided. It can also be downloaded from the Extron
website (www.extron.com).
The minimum system requirements for installing the program on the computer are:
Operating system — Microsoft
CPU — Intel
Hard disk space — 10 MB
Memory — 256 MB of RAM
Device connection — Serial Com Port
Install the program as described in
For either software or firmware, click the letter
initial R are listed (see figure 26,
Figure 26.
Downloading Firmware
Navigate to
RGB-DVI 300, RGB-HDMI 300, and RGB-HDMI 300 A
(see figure 27,
(Login required)
Figure 27.
Downloading Firmware
Follow the on-screen instructions. If you are downloading software, the software is installed
on your computer. If you are downloading firmware, an executable file (.exe) is installed on
your computer. Run that file to unpack the firmware and make a note of the folder where the
firmware is installed.
The file name is in the format
with the RGB-DVI 300, RGB-HDMI 300, or RGB-HDMI 300 A.
®
Pentium II processor with a 400 MHz clock speed
® ®
RGB DVI 300 and RGB HDMI 300 (A) • Software and Firmware
R in the alphabet menu. Products with the
).
1
1 ).
. The same firmware can be used
RGB_XXX_300_v1.01.bin
Windows 2000 or later
®
Downloading Software or Firmware
and click
Download
on the previous page.
25