Firmware Upgrades - Extron electronics RGB-DVI 300 User Manual

Firmware Upgrades

Firmware for the RGB-DVI 300, RGB-HDMI 300, or RGB-HDMI 300 A can be upgraded using
the Extron Firmware Loader utility by following the steps below:
1.
2.
3.
4.
5.
6.
7.
8.
Power on the scaler and a computer with internet access.
Connect the computer to the video scaler through either the front panel Config port or the
rear panel RS-232 captive screw connectors.
If necessary, download the firmware and install the Extron Firmware Loader utility. To
download software or firmware, see
Open the Extron Firmware Loader by double-clicking on the desktop icon or selecting it from
the start menu. The
Add Device...
Figure 31. Add Device... Dialog Box
From the drop-down menus, select the device name and the connection method (
If they are not automatically selected, add the COM port, and the baud rate.
Click . When the connection is made, the name of the device appears, with a green
Connect
check mark, in the Connected Device box.
Click and navigate to the folder where the firmware file was saved (see
Browse
"Downloading Software or Firmware" on page 25).
Click Add .
RGB DVI 300 and RGB HDMI 300 (A) • Software and Firmware
Downloading Software or Firmware
dialog box opens:
on page 24.
).
RS-232
step 6 of
27