Audio Command Symbols (Rgb-Hdmi 300 A Only); Error Messages - Extron electronics RGB-DVI 300 User Manual

X1*
= User presets — 1 to 3.
The parameters saved in user presets and input presets are:
User Presets
Contrast
Brightness
Detail
Table 7.
X2)
= Test parameters —
0= Off (default)
1= Color bars
2= Grayscale
3= 4 x 4 Crosshatch
4= Alternating Pixels
X2!
= RGB delay — 0 to 50 in tenths of a second (0 to 5
seconds; default = 5 [0.5 seconds]).
The screen blanks during transition between inputs
of different resolutions, to avoid glitches in the video
output.
X2@
On-screen menu time-out in seconds —
=
0 = No time out
1 to 64 in seconds (default = 10)
X2#
Horizontal and vertical frequencies — format is
=
three digits with single decimal and leading zeros.

Audio Command Symbols (RGB-HDMI 300 A Only)

X2*
Audio mute status —
=
0 = disabled
X2(
= Audio Gain (0 to +10 dB)
X3)
= Audio level (-18 to +10 dB)
X3!
= Audio attenuation (0 to -18 dB)
X3@
= Static delay: compensates for video signal
processing by other processors in the system
(0 - 255 ms)

Error Messages

If the RGB-DVI 300, RGB-HDMI 300, or RGB-HDMI 300 A does not support or recognize the entered
commands, one of the following responses may be issued.
E10
E11
E13
H position
V position
H size
V size
Zoom
Comparison of user presets and input presets.
5= Crop
6= 1.33 Aspect Ratio
7= 1.78 Aspect Ratio
8= 1.85 Aspect Ratio
9= 2.35 Aspect Ratio
1 = enabled
= Invalid command
= Invalid preset number
= Invalid parameter
X1(
= Input presets — 1 to 16.
NOTE: Input presets are available only through SIS
commands.
Input Presets
Input type H start
Total pixel V start
Contrast H active
Brightness V active
Detail Phase
X2$
= Internal temperature (in degrees Celsius)
X2^
= Overscan — applied only to SMPTE (480p - 1080p)
input rates:
0= 0% (default for RGB input type). A "true"
Auto-Image is executed on SMPTE inputs.
1= 2.5% (default for YUV input type). An
Auto-Image command snaps to a 2.5% table;
no true Auto-Image.
2= 5%. An Auto-Image command snaps to a
5% table; no true Auto-Image.
X2&
= User Preset Availability —
0= empty
X3%
Aspect ratio control setting —
=
1= fill
X3#
Digital Audio or Ancillary data output status —
=
0= HDMI data disabled
1= HDMI data enabled
2= HDMI data enabled if the EDID of the sink
contains a CEA extension block (default).
NOTE: This option is only available in units that shipped
after Q3 2010. Please consult the Extron Service
Department if you have any questions.
X3$
Audio Bit Depth (adjustable by SIS commands
=
only) —
16= 16 bit (default)
= Not valid for this config.
E14
= Invalid command for signal type
E17
= Busy
E22
RGB DVI 300 and RGB HDMI 300 (A) • SIS Commands
H position
V position
H size
V size
Zoom
1= saved
2= follow
24= 24 bit
31