Remote Unit Conditions Display
You can check selected Remote Unit info (Recording Conditions,
Current Measurements, and Battery Life, etc.)
※ Before selecting a Remote Unit you can run a search to find all Remote Units
with which communication is possible.Those units with which communication is
possible will appear with a
mark next to them. (See p.45 for details)
1.
In the Main Menu, open [ Gather Data] .
2.
Select the Remote Unit you wish to view.
① Select the group in which
the unit is registered.
3.
Click [ Get Rmote Info] .
4.
Once communication has been completed, the Remote Unit info
will be displayed.
①
②
③
④
43
② Select the unit you wish
to view.
① Recording Status:
...Recording
⑤
...Stopped
⑥
② Recording Interval:10 min
⑦
③ Recording Mode:
...One Time
⑧
...Endless
④ Battery Life
⑤ Communication Date and Time
⑥ Group Name
⑦ Remote Unit Name
⑧ Measurement at Time of
Communication
【For RVR-52 Pulse Recording】
The total number of pulse readings during the recording interval set when
●
recording settings were made for the Remote Unit will be displayed.
# of Pulses / Recording Interval
【If RVR-52 has been set for Event Recording Mode】
If upper and lower limits have been set a ▼ will appear in the lower left
●
corner of the display. By turning the operation dial you can view the limit
settings and the judgment results.
・Rising Edge (OFF → ON) :
・Falling Edge (ON → OFF) :
Recording Signal Condition
If no event data has been recorded,
[No Event Data] will appear.
44