Cable Communication; Recording Start - T&D RTR-57C User Manual

Cable Communication:

The following settings or changes can be made via the main unit.
Recording Start Time Setting (Programmed Start)
●
Recording Mode
●
Recording Interval
●
※ Please make temperature unit changes for the RTR-51/52/53 main units
and Measurement Mode changes for the RVR-52 units via the supplied
software『T&D Recorder for Windows 』
NOTE:
If you set the conditions during recording, all previously recorded data will
●
be lost. Make sure to make all Recording Start settings after having
download the recorded data.
If you make changes to the recording condition via the RTR-57C unit,
●
channel names may change. When you do not wish to change the names,
make sure to Read Settings before making changes.
※ RTR-51/52/53 and RVR-52 are not channel names, but are group or
remote unit names, so these names will not change.
【What does [Read Settings] mean?】
The recording conditions of a specified Remote Unit can be read into an
RTR-57C unit.
If you wish to restart recording without making any changes to the recording
conditions, specify the Remote Unit and click [Read Settings]. The recording
conditions of the specified Remote Unit will be displayed.
【Immediate Start】
1.
In the Main Menu. open [REC SETTINGS] - [Direct].
2.
Set the recording conditions.
29

Recording Start

Recording Modes:
One Time: Recording will stop when the data capacity becomes full.
Endless:Recording will continue with oldest data continuously overwritten.
Recording Interval:
Choose from 15 intervals: 1,2,5,10,15,20,30 seconds and 1,2,5,10,15,20,30 and
60 minutes.
Some recording intervals cannot be set on some types of the devices.
※
3.
Move the arrow to [Immediate] after setting the conditions.
4.
Connect the data logger to the RTR-57C and press the operation
dial to have the settings transmitted.
〔For RTR-51/52/53,RVR-52 and TR-51A/52〕
Place logger face down on RTR-57C
〔For TR-71S/72S〕
If light enters during communication,
●
an error will occur. Please make
sure to place the unit within the
ridges for an exact fit.
Connect using the included
communication cable (TR-3C10)
30