Configuring The Media Bay Module - Nortel BCM50 2.0 Installation Manual

Configuring the media bay module

For information on installing a media bay module (MBM) and setting the dip switches, refer to the
Installation and Maintenance Guide (NN40020-302).
To configure the MBM
1 Open Element Manager and connect to your BCM50 system.
2 Click Configuration > Resources > Telephony Resources.
The Telephony Resources panel appears (see
3
In the Modules table, select the location of the MBM that you want to configure.
4 Double-click the Programmed type field to display the drop-down list.
5 Select the type of MBM that you installed in that location.
6
Click Enable.
7 Repeat steps 4 to 7 to enable each MBM in your system.
You can set other parameters for the MBMs depending on the type of MBM you installed.
Chapter 3 Installing an analog station media bay module
Figure 27).
Telephony Device Installation Guide
21