Table of Contents
Advertisement
50
Ember Material Installation (GSR2 ONLY)
Once the ember glass installation is complete, place a generous amount of ember material on the firebox
floor on either side of the firebox. Completely cover any visible metal on the firebox floor.
NOTE: Make sure no ember material is placed directly on the burner.
HINT: Add a few randomly placed ember chunks over the ember bed glass to produce a more realistic
appearance.
Ember Installation (GSB2 or MV)
A bag of embers is provided to further enhance the
firebox. Place the embers on the firebox floor and
on the burner. Do not place embers over any of
the burner holes or air channels.
Rock Wool Placement (All Models)
The included rock wool is placed on top of the burner to enhance the glow from the burner. The rock wool works
best when it is applied in a very thin layer. The best method for applying the rock wool is to brush it on to the
burner. Compress a clump of rockwool between your thumb and forefinger. Use a stiff brush to apply a thin layer
of rockwool fibers onto the burner. Do not use the entire bag of rockwool. Use only a small amount and save the
remainder. Over-use of rockwool will diminish the glow and may cause sooting or other adverse conditions.
© Travis Industries
Installation
(for qualified installers only)
9/25/18 - 1488
PB36 CF Install
Advertisement
Table of Contents
