FireplaceXtrordinair ProBuilder 36 CleanFace MV Installation Manual page 56

56
4 Remove the switch from the dashboard by depressing the tabs on the top and the bottom of the switch housing while
pressing the back of the switch forward through the hole in the dashboard. Replace the switch with the included
switch blank (see pictures below).
5 Remove the battery holder. Disconnect the
red and black wire at the Molex connector.
6 Replace the battery holder with the battery
box included with this remote kit. Connect
the red and black wires to the wires you just
disconnected in step 5.
7 Place the battery box on the floor of the
fireplace.
8 Replace the dashboard.
9 Verify wires are not touching the bottom of the firebox. Adjust if necessary.
10 Install 4AA batteries into the receiver.
11 Install 3AAA batteries into the remote.
12 Sync the remote with the receiver (see syncing instructions included with remote).
13 Return the appliance to the correct configuration.
© Travis Industries
Installation
(for qualified installers only)
9/25/18 - 1488 PB36 CF Install