Ember Bed Glass And Ember Material Installation (Gsr2 Only); Ember Bed Glass Installation - FireplaceXtrordinair ProBuilder 36 CleanFace MV Installation Manual

Ember bed Glass and Ember Material Installation (GSR2 ONLY)

Ember bed Glass Installation

The Ember-Glo™ lights come standard on the GSR2 units. There are an optional accessory for GSB2 or MV units. If
the upgrade kit is not used in for the GSB2 or MV units, you may skip this section and proceed to Ember Installation.

Make sure the ember skirt is in place. The skirt hooks over the front of the ember platform and slopes outward
toward the glass. The skirt helps keep the glass and ember material from falling off the platform when the glass
is removed.

Locate the perforations in front of the log grate.

Place a thick layer of the ember glass over the perforations making sure to cover all of the holes completely.

Lightly dress the ember glass with the black touch-up paint provided. Check the appearance with the lights on
and add additional paint, as needed, for a realistic glowing ember appearance.
NOTE: If power is supplied to the fireplace it can helpful to turn the lights on while painting so you can determine an
appropriate amount of paint for a realistic ember appearance.
NOTE: We recommend that you use a piece of paper, cardboard as a shield to mask the log grate and burner from
overspray (see below).
© Travis Industries
Installation
(for qualified installers only)
9/25/18 - 1488
49
PB36 CF Install