Abbreviations Used In This Manual; Transmitter Installation Procedures; Flowmeter Documentation - Emerson Micro Motion 2700 Installation Manual

Before You Begin continued
The following examples illustrate use of the model number to determine transmitter type, installation
type, and output board type:
• 1700RxxAxxxxxx
•
2700CxxDxxxxxx
outputs option board
1.5

Abbreviations used in this manual

In this manual:
• AN = transmitters with the analog outputs option board
• IS = transmitters with the intrinsically safe outputs option board
• CIO = transmitters with the configurable input/outputs option board
1.6

Transmitter installation procedures

To install the transmitter, the following procedures are required:
• Install the transmitter – see Chapter 2
• Wire the transmitter to the sensor – see Chapter 3
• Wire the transmitter outputs:
- For Model 1700 or 2700 AN transmitters, see Chapter 4.
- For Model 1700 or 2700 IS transmitters, see Chapter 5.
- For Model 2700 CIO transmitters, see Chapter 6.
1.7

Flowmeter documentation

Table 1-1 lists documentation sources for other required information.
Table 1-1 Flowmeter documentation resources
Topic
Sensor installation
Core processor installation (if mounted
remotely from sensor and transmitter)
Transmitter configuration
Transmitter startup and use
Transmitter troubleshooting
Transmitter Installation: Model 1700 and 2700 Transmitters
= Model 1700 remote transmitter with analog outputs option board
= Model 2700 transmitter/core processor assembly with intrinsically safe
Document
Sensor documentation shipped with sensor
This document
Transmitter Configuration and Use:
Series 1000 and 2000 Transmitters
3