Chapter 1 Before You Begin; Overview; Safety - Emerson Micro Motion 2700 Installation Manual

Chapter 1
Before You Begin
1.1

Overview

This chapter provides an orientation to the use of this manual. This manual describes the procedures
required to install the following Series 1000 and Series 2000 transmitters:
• Model 1700 or Model 2700 with analog outputs option board
• Model 1700 or Model 2700 with intrinsically safe outputs option board
• Model 2700 with configurable input/outputs option board
If you do not know what transmitter you have, see Section 1.4 for instructions on identifying the
transmitter type from the model number on the transmitter's tag.
Note: Installation information for Model 2700 transmitters with F
Profibus-PA outputs is provided in a separate manual. See the manual for your transmitter.
Note: Installation information for Model 1500 transmitters or Model 2500 transmitters is provided in
a separate manual. See the manual for your transmitter.
1.2

Safety

Safety messages are provided throughout this manual to protect personnel and equipment. Read each
safety message carefully before proceeding to the next step.
Transmitter Installation: Model 1700 and 2700 Transmitters
WARNING
Improper installation in a hazardous area can cause
an explosion.
For information about hazardous applications, refer to
Micro Motion ATEX, IECEx, CSA, or UL installation
instructions, shipped with the transmitter or available from
the Micro Motion web site.
WARNING
Hazardous voltage can cause severe injury or death.
Make sure power is disconnected before installing
transmitter.
™
fieldbus or
OUNDATION
1