Operation; Controls; Operating The Steamer - Vulcan-Hart C24EO3 Installation & Operation Manual

C24EO SERIES STEAMER

CONTROLS

: The steamer and its
parts are hot. Use care when operating,
cleaning or servicing the steamer. The
cooking compartment contains live steam
and hot water. Stay clear when opening
the door.
Overfill
Light
Figure 7: Controls
Power Switch/Low Water Reset:
unit OFF/ON/RESETS LOW WATER LIGHT/
ALARM.
Low Water Light: When lit, indicates additional
water is required.
Timer: Selects the desired cooking time or the
CONTINUOUS position.
COOK Light: When lit, indicates the timer is
set and door is closed.
OVERFILL Light: (Auto-Fill model only): When
lit, indicates a problem with the Auto-Fill function
(an audible alarm will sound in the event of an
overfi ll condition).

OPERATION

OPERATING THE STEAMER

1. Push the drain lever in to close the drain
valve.
2. Open the door and pour water into the
cooking compartment up to the water level
mark. The water level mark is visible on the
back wall of the steamer. Unit capacity is 3
gallons. Do not overfi ll.
3. Close door.
NOTE: On Auto-Fill model, the unit will
4. Verify Timer is in the OFF position.
5. Fully depress Power Switch to ON
position. Power light in switch will illuminate
amber.
6. Set timer to 5 minutes. In approximately 15
minutes unit will be preheated and ready to
cook.
7. Set timer to desired time (0 to 60 minutes)
or to CONTINUOUS position.
Turns
8. At the end of the timed cycle an audible
alarm will sound.
9. The unit returns to the idle temperature.
NOTE: Timer will not function until preheat has
— 12 —
automatically fi ll with water once the start
button is pressed. The steamer will fi ll
until water reaches the water level probe
located inside the cavity. If the door is
closed, the steamer will heat the water
during the initial fi ll cycle.
been completed.