Intermec PC23 User Manual page 136

Chapter 6 —
124
Setting
Odometer (User
Resettable)
Odometer (Printer)
Odometer (Current
Printhead)
Replace Printhead
Clean Printhead
Faulty Dot
Ribbon Low
Diameter
Description
Sets the length of media (in meters) that the
printer prints before the Odometer (User
Resettable) alert is sent, if this alert is
configured. Unit of measurement is defined
in the Unit of Measure parameter. Range is 0
to 4294967295.
Sets the length of media (in meters) that the
printer prints before the Odometer (Printer)
alert is sent. Unit of measurement is defined
in the Unit of Measure parameter. Range is 0
to 4294967295.
Sets the length of media (in meters) that the
printer prints before the Odometer (Current
Printhead) alert is sent, if this alert is
configured. Unit of measurement is defined
in the Unit of Measure parameter. Range is 0
to 4294967295.
Sets the length of media (in meters) that the
printer prints before the Replace Printhead
alert is sent, if this alert is configured. Unit of
measurement is defined in the Unit of
Measure parameter. Range is 0 to
4294967295.
Sets the length of media (in meters) that the
printer prints before the Clean Printhead
alert is sent, if this alert is configured. Unit of
measurement is defined in the Unit of
Measure parameter. Range is 0 to
4294967295.
Sets the number of faulty dots on the
printhead before the Faulty Dot alert is sent,
if this alert is configured. Range is 0 to
4294967295.
Sets the minimum diameter of the ribbon
roll before the Ribbon Low alert is sent, if this
alert is configured. Range is 0 to 200 mm.
PC23 and PC43 Desktop Printer User Manual
Default
0
N/A
0
0
0
0