Transporting - Exmark LAZER Z Series Operator's Manual

Operation
Underside of 96 Inch Deck
1. Anti-scalp roller
Adjusting the Side Bumpers
(Rear Discharge Units Only)
Mount the side bumpers in the top holes when
operating in height of cuts higher than 2 1/2 inches
(64 mm) and in the center holes when operating in
height of cuts lower than 2 1/2 inches (64 mm).
Note: When bumpers become worn, switch the
bumpers to the opposite sides of the mower, flipping
them over. This allows the bumpers to be used longer
before replacing them.
1. Stop the machine and move the motion control
levers outward to the neutral locked position.
2. Disengage the PTO.
3. Engage the park brake.
4. Stop the engine, remove the key and wait for all
moving parts to stop.
5. Raise the deck to the transport position.
6. Remove the bolts and nuts from each bumper.
Figure 22
1. Bolt
2. Bumper
7. Move each bumper to the desired position and
g238020
secure them with the bolts and nuts.
Note: Only use the top or center sets of holes to
adjust the bumpers. The bottom holes are used
when switching sides, at which time they become
the top holes on the other side of the mower.

Transporting

Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary lighting and marking as required by law.
Thoroughly read all of the safety instructions.
Knowing this information could help you, your
family, pets, or bystanders avoid injury.
To transport the machine:
• Lock the brake and block the wheels.
• Securely fasten the machine to the trailer or truck
with straps, chains, cable, or ropes. Only use the
designated tie-down locations on the mower (see
Figure 24 and Figure 25). Use these locations even
when transporting the mower with an attached
accessory. Using non-designated locations may
cause damage to the mower and/or attachment.
36
Figure 23
3. Nut
g238205