Exmark LAZER Z Series Operator's Manual page 67

Problem
Mower pulls left or right (with levers fully
forward)
Machine does not drive
Uneven cutting height.
Abnormal vibration
Blades do not rotate.
Clutch will not engage.
Possible Cause
1. Tracking needs adjustment.
2. Tire pressure in drive tires not correct.
3. Reverse indicator and motion control
linkage need adjustment.
1. By pass valve is not closed tight.
2. Hydraulic fluid level is low or too hot.
1. Blade(s) not sharp.
2. Cutting blade(s) is/are bent.
3. Mower deck is not level.
4. Underside of mower is dirty.
5. Tire pressure in drive tires not correct.
6. Blade spindle bent.
7. Tips of adjacent blades are at an uneven
cutting height. Blades tips should be even
within 3/16 inch which is approximately
one blade thickness.
1. Cutting blade(s) is/are bent or unbalanced.
2. Blade mounting bolt is loose.
3. Engine mounting bolts are loose.
4. Loose engine pulley, idler pulley, or blade
pulley.
5. Engine pulley is damaged.
6. Blade spindle is bent.
7. Belt is damaged.
1. Drive belt is worn, loose or broken.
2. Drive belt is off pulley.
3. Deck belt is worn, loose or broken.
4. Deck belt is off pulley.
5. Broken or missing idler spring.
6. Clutch has disengaged.
7. Wings are not fully lowered.
1. Fuse is blown.
2. Low voltage supply at the clutch.
3. Inadequate current supply.
4. Engine has overheated.
5. Wings are not fully lowered.
67
Troubleshooting
Corrective Action
1. Adjust the tracking.
2. Adjust tire pressure in the drive tires.
3. Adjust the reverse indicator and the
motion control linkage.
1. Tighten the by pass valve.
2. Add hydraulic fluid to reservoir or let it
cool down.
1. Sharpen the blade(s).
2. Install new cutting blade(s).
3. Level mower deck from side-to-side and
front-to-rear.
4. Clean the underside of the mower.
5. Adjust tire pressure in the drive tires.
6. Contact an Authorized Service Dealer.
7. Replace blades, spindles and (or) check
for damage to mower deck.
1. Install new cutting blade(s).
2. Tighten the blade mounting bolt.
3. Tighten the engine mounting bolts.
4. Tighten the appropriate pulley.
5. Contact an Authorized Service Dealer.
6. Contact an Authorized Service Dealer.
7. Install new belt.
1. Check the belt tension.
2. Check belt for damage; replace if
necessary. Install drive belt and check belt
guide for correct position.
3. Install new deck belt.
4. Install deck pulley and check the idler
pulley, idler arm and spring for correct
position and function.
5. Replace the spring.
6. Engine has overheated; determine cause
of overheat (see Engine overheats).
7. Lower the wings.
1. Replace fuse. Check coil resistance,
battery charge, charging system, and
wiring connections and replace if
necessary.
2. Check coil resistance, battery charge,
charging system, and wiring connections
and replace if necessary.
3. Repair or replace clutch lead wire or
electrical system. Clean connector
contacts.
4. Determine cause of overheat (see Engine
overheats).
5. Lower the wings.