Exmark LAZER Z Series Operator's Manual page 35

mm) clearance to the ground to minimize gouging
and roller wear or damage.
For cutting heights above 3.5 inches (90 mm) use the
bottom hole. The rollers will still be effective against
1. Anti-scalp roller
mounting bracket
For Maximum Deck Flotation, place the rollers
one hole position lower. Rollers should maintain
1/4 inch (6.4 mm) clearance to the ground. Do
Not adjust the rollers to support the deck.
7. Reinstall the mounting hardware:
• Side Discharge Models:
A. Be sure the roller bolts are installed with
the spring disc washer between the head
of the bolt and the mounting bracket (see
Figure 20).
B. Torque the 3/8 nyloc nut to 50–55 ft-lb
(68-75 N-m).
Figure 19
scalping.
2. Cutting height
g035118
1. 3/8-16 X 3 3/4 Grade 8
bolt
2. Spring disc washer
(cone towards bolt head)
• Rear Discharge Models:
Torque the 3/8 nyloc nut to 30-35 ft-lb (41-47
N-m) (see Figure 21).
1. 3/8 nyloc-torque to 30-35
ft-lb (41-47 N-m)
2. Anti-scalp rollers
The 96 inch deck has 13 anti-scalp roller locations to
adjust see Figure 22.
35
Operation
Figure 20
3. Front right anti-scalp
bracket shown
4. 3/8 nyloc-torque to 50-55
ft-lb (68-75 N-m)
Figure 21
3. Spacer
4. Bolt
g023992
g018862