Safety And Instructional Decals - Exmark LAZER Z Series Operator's Manual

Safety and Instructional Decals

• Keep all safety signs legible. Remove all grease,
dirt and debris from safety signs and instructional
labels.
• Replace all worn, damaged, or missing safety
signs.
• When replacement components are installed, be
sure that current safety signs are affixed to the
replaced components.
• If an attachment or accessory has been installed,
make sure current safety signs are visible.
93-6687
96 Inch Models Only
1. Do not step here.
99-8936
1. Machine speed
2. Fast
3. Slow
106-5517
1. Warning—do not touch the hot surface.
decal93-6687
decal99-8936
4. Neutral
5. Reverse
decal106-5517
• New safety signs may be obtained from
your authorized Exmark equipment dealer or
distributor or from Exmark Mfg. Co. Inc.
• Safety signs may be affixed by peeling off the
backing to expose the adhesive surface. Apply
only to a clean, dry surface. Smooth to remove
any air bubbles.
• Familiarize yourself with the following safety signs
and instruction labels. They are critical to the safe
operation of your Exmark commercial mower.
1. Warning-there is no rollover protection when the roll bar
is down.
2. To avoid injury or death from a rollover accident, keep
the roll bar in the fully raised and locked position
and wear the seat belt. Lower the roll bar only when
absolutely necessary; do not wear the seat belt when
the roll bar is down.
3. Read the Operator's manual; drive slowly and carefully.
11
Safety
107-3069
decal107-3069