Table of Contents
Advertisement
Note: Reverse gear is reverse assist only, the operator
must pull the unit backwards.
To move rearward, squeeze the drive levers to neutral
position and move the shifter to the "R".
Smoothly release both drive levers to engage drive
wheels.
Pull the unit backward to "assist" with the movement
of the unit.
To stop, squeeze drive levers all the way back to
engage the brakes. Move the neutral lock latches into
the "park brake" position and release drive levers.
Move the speed control lever to the neutral position.
Changing Gears
When changing gears, always squeeze drive levers to
the neutral position. The shift lever may be moved
with a knee or by hand (engage the neutral lock
latches if shifting by hand).
Note: Reverse gear is "reverse assist" only, the
operator must pull the unit backwards.
After Operation
General Safety
• Park machine on level ground, disengage drives,
set parking brake, stop engine, remove key,
and disconnect spark plug wire. Wait for all
moving parts to stop before leaving the operator's
position. Allow the machine to cool before
servicing, adjusting, fueling, cleaning, or storing.
• Clean grass, leaves, excessive grease or oil, and
other debris from the mower deck, muffler, drives,
grass catcher, and engine area to help prevent
fires.
• Close the fuel shut-off valve before storing or
transporting the machine.
Transporting
Transporting the Machine
WARNING
Loading the mower onto a trailer without strong
enough or properly supported ramps could be
dangerous. The ramps could collapse causing
the unit to fall, which could cause injury.
• Use proper ramps that are secured to the
truck or trailer.
• Keep feet and legs out from under the unit
when loading and unloading.
• If necessary, use assistance when loading.
Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary lighting and marking as required by law.
Thoroughly read all of the safety instructions.
Knowing this information could help you, your
family, pets, or bystanders avoid injury.
To transport the machine:
• Use full width ramps when loading the machine.
• Be sure the fuel shut-off valve is closed.
• Engage neutral lock latches and park brake, then
block the wheels. Do Not rely solely on the
parking brake to hold the machine on the trailer.
• Securely fasten the machine to the trailer or truck
with straps, chains, cable, or ropes. If possible,
both front and rear straps should be directed
down and outward from the machine.
• Secure a trailer to the towing vehicle with safety
chains.
21
Operation
Advertisement
Table of Contents
