Exmark LAZER Z Series Operator's Manual page 33

To turn left or right, pull the motion control lever
back toward neutral in the desired turn direction.
The machine will move faster the farther the
motion control levers are moved from the neutral
position.
4. To stop, position both motion control levers in
the neutral operate position.
Driving in Reverse
1. Move the motion control levers inward to the
neutral operate position.
2. To move rearward in a straight line, move both
levers rearward with equal pressure.
Figure 15
Figure 16
To turn right, release pressure on the RH motion
control lever and the rear of the machine will
move towards the rear and to the right.
To turn left, release pressure on the LH motion
control lever and the rear of the machine will
move towards the rear and to the left.
3. To stop, position both motion control levers in
the neutral operate position.
Adjusting the Cutting Height–
60 and 72 Inch Decks
The cutting height of the mower deck is adjusted
from 1 to 5 1/2 inches (2.54 cm to 14 cm) in 1/4
inch (6.4 mm) increments.
1. Stop the machine and move the motion control
g016947
levers outward to the neutral locked position.
2. Disengage the PTO.
Note: When changing the cutting height
positions, always come to a complete stop
and disengage the PTO.
3. Press the top of deck lift switch, on the panel
control, to raise the deck. Push the bottom of the
switch to lower the deck.
4. Insert the height adjustment pin into the hole
corresponding to the desired cutting height.
See the decal on the side of the deck lift plate for
cut heights.
Adjusting the Cutting Height–
96 Inch Deck
The cutting height of the mower deck can be adjusted
from 1 to 5 1/2 inches (2.54 cm to 14 cm) in 1/4
inch (6.4 mm) increments.
1. Position the mower on a flat surface.
2. Disengage the PTO.
3. Press the top of deck lift switch, on the panel
control, to raise the center deck and the outer
wings.
4. Stop engine, wait for all moving parts to stop and
engage the parking brake.
5. Adjust the center deck:
g016948
A. Remove the height adjustment pin from the
deck lift plate on the right side of the center
deck.
33
Operation