Lubricate Grease Fittings; Check Wheel Lug Nuts - Exmark LAZER Z Series Operator's Manual

Lubricate Grease Fittings

Note: See chart for service intervals.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Lubricate fittings with one to two pumps of
NLGI grade #2 multi-purpose gun grease.
Refer to the following chart for fitting locations
and lubrication schedule.
60 and 72 inch Models
Lubrication Chart
Fitting Initial
Locations Pumps
1. Deck 1
drive PTO
2. Deck 1
idler pivot
3. Caster *0
wheel
bearings
4. Caster *0
pivots
Number of Service
Places Interval
3 50 hrs
1 Every 400
hrs or
Yearly
2 *Yearly
2 Every 400
hrs or
Yearly
96 inch Model
Lubrication Chart
Fitting Initial
Locations Pumps
1. Deck 1
drive PTO
2. Deck 1
idler pivot
3. Caster *0
wheel
bearings
4. Caster *0
pivots
* See step 3 for special lubrication instructions on
the front caster pivots and the Lubricate Caster
Wheel Hubs section for special lubrication
instructions on the front casters wheel hubs.
3. Lubricate front caster pivots once a year. Remove
hex plug and cap. Thread grease zerk in hole and
pump with grease until it oozes out around top
bearing. Remove grease zerk and thread plug back
in. Place cap back on.

Check Wheel Lug Nuts

Service Interval: After the first 100 hours
49
Maintenance
Number of Service
Places Interval
3 50 hrs
3 Every 400
hrs or
Yearly
4 *Yearly
5 Every 400
hrs or
Yearly