Verifying The Network Clock Configuration - Cisco ASR 1000 Series Software Configuration Manual

Configuring the Circuit Emulation over Packet Shared Port Adapter
Command or Action
Step 3 Router(config)# controller sonet
slot/subslot/port
Step 4
Router(config-controller)# clock
source {line | internal}
Step 5 Router(config-controller)# exit
Step 6 Router(config)# exit
Step 7 Router# show network-clocks
Step 8 Router# debug network-clock
Step 9 Router# debug network-clock
redundancy

Verifying the Network Clock Configuration

Use the show network-clocks command to verify the output on the RP:
Router# show network-clocks
Active source = SONET 0/1/0
Active source backplane reference line = Primary Backplane Clock
All Network Clock Configuration
---------------------------------
Priority
1
Current operating mode is Revertive
Current OOR Switchover mode is Switchover
There are no slots disabled from participating in network clocking
Configuring Clock Recovery
When configuring clock recovery, consider the following guidelines:
Adaptive Clocking
OL-14127-17
Purpose
When the revertive mode is configured and a previously unavailable
higher-priority source comes up, this source becomes the active clock and the
previous active source becomes the standby clock. The revertive mode is the
default mode and is applicable for all types of interface failures. The alternate
source is selected only if there is an interface failure; the alternate source is not
selected when a source is supplying a bad clock.
The no form of this command configures the nonrevertive mode.
Enters the Controller configuration (config-controller) mode.
Enables network clocking and configures clocking on the interface.
• line—Specifies the clock that has been recovered from the line.
• internal—Specifies the SPA internal clock or the clock from the host.
Exits Controller configuration mode and enters the global configuration mode.
Exits global configuration mode and enters the Privileged EXEC mode.
Displays details about the configured clocks and the current operational clocks,
and provides status information.
Helps in debugging the network clocking feature operation.
Enables high availability-related debugging.
Clock Source
SONET 0/1/0
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
State
Valid
Configuring Clock Recovery
Reason
Everest 16.5
519